10 Years manufacturer 5083 marine grade aluminium plate for Singapore Factory

Short Description:


Product Detail

FAQ

Product Tags

We support our buyers with ideal high quality products and high level service. Becoming the specialist manufacturer in this sector, we have gained rich practical experience in producing and managing for 10 Years manufacturer 5083 marine grade aluminium plate for Singapore Factory, We are sincere and open. We look forward to your visit and establishing trustworthy and long-term standing relationship.


 5083 marine grade aluminium plate

Aluminium alloy 5083 contains 5.2% magnesium, 0.1% manganese and 0.1% chromium. In the tempered condition, it is strong, and retains good formability due to excellent ductility. 5083 has high resistance to corrosion, and is used in marine applications. It has the low density and excellent thermal conductivity common to all aluminium alloys.

 

Chemical Composition Limit Of Aluminum Alloys
ALLOY Si Fe Cu Mn Mg Cr Zn Ti Others Al
Each Total Min
5083 0.4 0.5 1.0 0.4-1.0 4.0-4.9 0.05-0.25 0.25 0.15 0.05 0.15 Remain

 

 

alloy 5083
temper H116 ,H321, O, H112 , H32,etc
thickness 1–300mm
length 1000–10000mm
width 1000-4000mm
surface condition mill finished
intergranular corrosion no greater than 15mg/cm²
exfoliation corrosion PB or better

Application

-  Ship board;

-  heatproof apparatus, material for interior and exterior of building;

-  Parts of Electronic tools;

-  Automobile Components.

  • Previous:
  • Next:
  • FAQ Content




  • Making a simple, but accurate center finder from scraps of laminate flooring. It will be used mostly for woodturning, to mark the center of blanks.

    Laminate flooring is a great material for workshop projects since it’s basically MDF covered in melamine on both sides.

    I used the factory edges to get an accurate square then used it’s diagonal to mark the 45 degree angle for the ruler. The ruler itself is a piece of leftover aluminum transition strip.

    ==========

    If you want to help in the making of these videos you can support me on Patreon: https://www.patreon.com/TheSmallWorkshop?ty=h



    https://www.neo7cnc.com

    In this video I’m cutting some test brackets out of 1/4 thick aluminum. Cutting speed is 30 IPM, 0.05 DOC, 50% step over, 24k RPM using a 1/8 carbide single flute cutter. I’m using an air blower to cool the bit and remove the chips.

    The finish wasn’t bad. There are some small deviations in the finish due to the 1/8 bit but it sanded up just fine. I hand reamed the holes to true 0.25

    Send your message to us:

    Write your message here and send it to us

    Related Products

    Send your message to us:

    Write your message here and send it to us