Fast delivery for Colour coated aluminum coils for roofing ceiling to Switzerland Factories
With reliable quality process, good reputation and perfect customer service, the series of products produced by our company are exported to many countries and regions for Fast delivery for Colour coated aluminum coils for roofing ceiling to Switzerland Factories, Looking to the future, a long way to go, constantly striving to become the all staff with full enthusiasm, one hundred times the confidence and put our company built a beautiful environment, advanced products, quality first-class modern enterprise and work hard!
Colour coated aluminum coils for roofing ceiling
||1100, 1050, 1060, 1200, 3003, 3105, 5052, 5005
|| PVDF Over 25 micron, PE over 20 micron
||According to customer’s requirement, normally is 2MT or so
||White series, metallic series, Dark series, Gold series( accept color customs)
|Standard Exporting Wooden Pallet
We also produce aluminum tread plates,aluminum foils ,aluminum circle ,etc.Welcome your inquiry.
Summer School Venice 2016
Enrico Crivellari (IUAV di Venezia)
Domenica Polverini (Politecnico di Torino)
Paulina Schroeder (FH Potsdam)
Jan Wähning (TU Dortmund)
Video tutorial on how to drill and tap threads into aluminum. In this video I have used a specific type of tap called a “gun tap” which allows me to make a straight run/cut of threads into the material without having the need to continuously back the tap out of the hole to keep the cutting threads clean. Other types of taps need to be backed out of the hole after a few new thread cut in order to reduce the risk of material binding and keeping a clean cut. It is always good practice to buy high quality taps as they will last a very long time and it reduces the risk of breaking due to higher quality materials used. The piece I am working with today is an anti shudder valve from a Volkswagen diesel. The reason I am added threaded holes to the unit is so that I am able to install grub screws to hold the boost pipe in place without it popping open under pressure and causing a boost leak. The tabs on the pipe are worn out therefore the grub screws will hold it in place instead. This is an inexpensive and easy fix for the current issue. A new replacement pipe from the dealer is worth $100, eventually down the road it will run into the same problem.
Google Plus: https://plus.google.com/+4DIYers
-ensure that the object you are working with is clean
-ensure that the tap you are using is clean
-mark out where you would like the threaded hole, then using a center punch and a hammer mark the center of the hole
-the center punch marks the center of the hole and will reduce the risk of the drill bit wandering
-using a drill and tap index, determine what size drill bit is required for the hole
-the drill bit must be smaller than the tap size
-clamp the object down to ensure it doesn’t move while also reducing the risk of a safety hazard
-use cutting oil if needed when drilling the hole
-clean the hole before getting ready to tap threads
-apply cutting oil to the tap and hole
-ensure the newly drilled hole and tap is lined up correctly
-don’t use the drill press’ power for this procedure
-slowly feed the tap down to the object and turn the drill chuck by hand
-apply cutting oil when needed
-feed the tap all the way in the hole, then loosen the chuck and allow the chuck to be removed from the tap
-remove the tap by hand
-clean any cut material away from the hole
-clean tap when done before putting away
Thank you to all those who watch my videos and support my content. Don’t forget to subscribe to my channel for future tutorial videos and like my video if you found it helpful. New videos are always being uploaded every week!
© 4DIYers 2013
All Rights Reserved
No part of this video or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author.