China supplier OEM 5083 marine grade aluminium plate Supply to Las Vegas

Short Description:


Product Detail

FAQ

Product Tags

We support our buyers with ideal high quality products and high level service. Becoming the specialist manufacturer in this sector, we have gained rich practical experience in producing and managing for China supplier OEM 5083 marine grade aluminium plate Supply to Las Vegas, We sincerely welcome overseas customers to consult for the long-term cooperation and the mutual development.We strongly believe that we can do better and better.


 5083 marine grade aluminium plate

Aluminium alloy 5083 contains 5.2% magnesium, 0.1% manganese and 0.1% chromium. In the tempered condition, it is strong, and retains good formability due to excellent ductility. 5083 has high resistance to corrosion, and is used in marine applications. It has the low density and excellent thermal conductivity common to all aluminium alloys.

 

Chemical Composition Limit Of Aluminum Alloys
ALLOY Si Fe Cu Mn Mg Cr Zn Ti Others Al
Each Total Min
5083 0.4 0.5 1.0 0.4-1.0 4.0-4.9 0.05-0.25 0.25 0.15 0.05 0.15 Remain

 

 

alloy 5083
temper H116 ,H321, O, H112 , H32,etc
thickness 1–300mm
length 1000–10000mm
width 1000-4000mm
surface condition mill finished
intergranular corrosion no greater than 15mg/cm²
exfoliation corrosion PB or better

Application

-  Ship board;

-  heatproof apparatus, material for interior and exterior of building;

-  Parts of Electronic tools;

-  Automobile Components.

  • Previous:
  • Next:
  • FAQ Content




  • As a general statement, there are two types of copper used in the Printed Circuit Board (PCB) industry- Electro Deposited Copper (ED) and Rolled Copper. In this video segment, John Coonrod will explain how these two different copper types and treatment affect insertion loss.



    5kW TOCCOtron AC induction heating power source with light weight hand held transformer used to apply fast focused flameless electromagnetic heat to seized head studs, thus greatly reducing the amount of torque required to remove them. Heating the stud causes it to elongate because its diameter is constrained by the cold engine block. The elongation of the stud reduces its diameter breaking corrosive bonds. Additional heat is applied to the outside of the engine block in the threaded area to expand the threaded area further separating the corrosive bonds. This technology is also ideal for shrink fitting of bearings and gears, removing pressed in valve seats, brazing/soldering of fluid lines and electrical connectors as well as curing and removing of coatings and sealants.

    Related Products