China Factory for 7075 Aluminium Sheet for Israel Factories

Short Description:


Product Detail

FAQ

Product Tags

We consistently carry out our spirit of ''Innovation bringing development, Highly-quality ensuring subsistence, Management promoting benefit, Credit attracting customers for China Factory for 7075 Aluminium Sheet for Israel Factories, we are now looking forward to even greater cooperation with overseas customers based on mutual benefits. If you are interested in any of our products, please feel free to contact us for more details.


 7075 Aluminium Sheet

We are China 7075 aluminium sheet manufacturers ,For more detailed information, please  feel free to contact us directly.

Specification Name: 7000 series Aluminum Sheet
Alloy: 7075
Temper: H112, T6, T651 etc.
Thickness: 6-200mm
Width: Up to 1500mm
Surface treatment: mill finished, Print marks
Feature High strength and heat treatable alloy
Good mechanical properties
Easy processing, good abrasive resistance
Good corrosion and oxidation resistance
Application Aerospace industry, blow molding (bottle) mold, ultrasonic plastic welding mold, high child husband ball, shoe, paper and plastic molding, foam molding, lost wax mold, templates, fixtures, machinery and equipment, mold processing etc.
 
Alloy Chemical Component %≤
Si Fe Cu Mn Mg Cr Ni Zn Ti others Al
single total
7075 0.4 0.5 1.2-
2.0
0.3 2.1-
2.9
0.18-0.2 5.1-
6.1
0.2 0.05 0.15 remainder
  • Previous:
  • Next:
  • FAQ Content




  • technically you are not supposed to run the RC-1 channel parallel with anything, but I did at the soffit abutment for about 14 inches or so…outside of that it helps reduce sound transmission by eliminating the surface area that sound will resonate thru (the joist/truss above). The soffit is for breaking up the ceiling height change from kitchen to living room and to allow me to run some LED light strips maybe, mostly for a little bling and a place to put some antiques or pictures or what evers……ceilings in the actual kitchen, bath and master bedroom are done with drywall grid which will as well help with sound transmission from above due to the supports are the only area of attachment to above rather than having gypsum directly applied to the floor joists(truss) above. I stated 1 & 1/4 as I was thinking of the commercial light guage studs this stuff is usually applied to, but with the wood, transmission area is approximate at 1/2″ x 1 & 1/2″…also by me doing this I was able to get back to a more appropriate 16″ on center for ceilings which will eliminate potential long term sagging of the gypsum as I will be using 1/2″ on the ceilings/lid.



    Full Automatic Aluminum Foil Rewinding Machine
    FANRS MACHINERY

    Related Products